Rectangular and oblong molded bellows for duct transitions, machine apertures and rectangular flanges — molded-in corner radii, clamping frames, EPDM or silicone to drawing.
Rectangular bellows solve a problem a round mold cannot: square and oblong openings. Duct transitions, machine-tool enclosures, air handlers and conveyor transfers rarely present a circular flange, and forcing a round bellows onto a rectangular frame concentrates stress in four corners until the wall splits.
Design Rules That Keep It Alive
The corner radius carries most of the risk. A sharp internal corner is a stress riser, so we mold a radius into every corner and keep the wall thickness uniform around the perimeter — a thick corner and a thin flat is how rectangular bellows fail early. The convolution depth is set by the movement you need, and the flat runs stay shallow where the span is long.
Rectangular bellows are usually clamped rather than flanged: a frame on each end, bolted through the molded flange, spreads the load and lets the boot be replaced without cutting ductwork.
Where Rectangular Bellows Fit
- HVAC duct transitions and fan connections: absorb movement and isolate vibration
- Fume extraction and dust-collection ducting: compensate fan and duct movement
- Machine-tool and laser enclosures: seal the aperture around a moving head
- Air handlers and clean-air plenums: flexible connections at rectangular flanges
- Conveyor and chute transfers: dust sealing across a rectangular gap
Material Choice
EPDM is the default for outdoor ducting and washdown, neoprene adds ozone and refrigerant resistance, NBR suits oil-mist and hydraulic environments, and silicone takes the high end at -60°C to 230°C. Compounds are RoHS and REACH compliant, and food-grade silicone is available on request for process-air duty.
What to Send for a Quotation
- Opening width, height, corner radius and overall length
- Axial movement, plus any lateral offset at the corners
- Pressure or vacuum the duct carries
- Frame or flange details, bolt spacing and clamp style
- Media: outdoor air, oily mist, washdown, food-contact air
Tooling quotes come in 7 days, quotations within 24 hours, samples in 7-12 working days.
FAQ
Can you mold a rectangular bellows with sharp corners?
No, and you should not want one. We mold a radius into each corner because a sharp internal corner is where the wall tears first. Send the frame dimensions and we will propose the largest radius the aperture allows.
Is a rectangular bellows pressure-rated?
Ductwork usually runs at low pressure or slight vacuum, and rectangular bellows are sized for that duty. If the plenum is pressurized, tell us the figure so we can add reinforcement at the corners and along the long flats.
How is it attached to the duct?
Normally with a bolted clamping frame over the molded flange. That spreads the load along the perimeter and lets the bellows be swapped without cutting the duct; threaded studs on a frame are also possible.