Custom FKM Fluoroelastomer Parts Manufacturer

Custom FKM parts for fuel, oil and chemical service: -20 °C to 200 °C, Shore A 50-90, density about 1.9 g/cm³, molded O-rings and high-temp gaskets.

Fluoroelastomer, FKM, is the compound we quote when the fluid is the hard part of the specification. Fuel, oils and aggressive chemicals that would take apart an NBR seal in weeks are handled here, and the part keeps working at temperatures where nitrile has already hardened.

What This Compound Handles

Fuel, oil and chemical service from −20 °C to 200 °C, at Shore A 50 to 90. That is the narrowest hardness band and the highest cost per kilogram in the four compounds we run, so FKM gets specified where nothing else survives rather than as a default. O-rings and seals for fuel systems, chemical process fittings and high-temperature gaskets are the three applications we mold most.

The trade is cold. At −20 °C the material is at the end of its range, so a part that has to seal on a cold start needs the low-temperature requirement stated on the drawing, not assumed. Where the duty is water, steam or weather rather than chemistry, EPDM covers −50 °C to 150 °C at a fraction of the price. Where the duty is mineral oil alone, NBR covers −40 °C to 120 °C.

Density is about 1.9 g/cm³, the heaviest of the four, which matters in a weight-sensitive assembly and in the cost calculation, since you buy the part by volume and pay by mass.

Where We Mold It

Compression and transfer molding, plus die-cutting for flat gaskets from sheet. Compression covers most O-ring and seal geometries. Transfer molding is used where the charge has to be distributed before cure, which is common on parts with thin walls and thick bosses in the same section. Die-cutting covers flat gaskets for flange work.

Tooling is built in house, so a cavity revision does not wait on an outside shop. Ten compression presses run in a 7,000 m² plant, and every part gets a 100% visual inspection before packing. On a part this expensive per piece, that inspection is the last cheap step in the process.

Hardness, Colour and Compliance

Shore A 50 to 90. The band starts higher than the other three compounds because soft FKM compounds are difficult to process and rarely worth the compromise. Hardness is stated on the drawing and checked against the production batch.

Color is usually black or a brown selected for identification between compounds on the same assembly, matched to a Pantone reference or a physical sample. Laser marking is available for part numbers and lot codes. The plant is ISO 9001, ISO 14001 and IATF 16949 certified. RoHS and REACH declarations are issued on request for the specific compound and color.

What to Send for a Quote

A 2D drawing with the critical dimensions, or a 3D STEP or IGES model. Name the fluid and the service temperature, because those two facts decide whether FKM is the right compound at all and which grade within it. Add the hardness, the annual volume, and a target price if you have one. If the part follows a standard such as AS568 or ISO 3601, send the standard number and the size designation.

Tooling is quoted within 7 days and first samples follow in 7–12 working days. We return the quote within one business day of receiving the drawing. Mold cost and MOQ are returned on volume.

Other Compounds We Mold

Need parts in this category?

Send your drawing, sample or spec — engineers reply within 1 business day with tooling and unit-cost direction.